Honda Power Equipment 08A06-3E1-300 manual Symptoms, Cause, Solution

Page 16
CD Changer

In Case of Difficulty

SYMPTOMS

Skips.

Stuck on one track.

CD ejects during play.

CAUSE

Scratches. 1

Fingerprint marks or dust. (Unclean sur- face.) 2

SOLUTION

Handle CD by edge only.

Keep CD clean by using a cleaning kit specifically designed for CDs.

Load CD straight and

level, not at an angle, to prevent further scratching.

SYMPTOMS

CD loads, then ejects after a few sec- onds.

CAUSE

CD not being centered on clamping mech- anism. 4

SOLUTION

CD center hole defective, preventing table of contents (TOC) to be read, trig- gering the eject mechanism. Defective CD should not be in CD Changer.

SYMPTOMS

Skips.

Stuck on one track.

CD ejects during play.

CAUSE

Pin holes in CD caused during stamping process-reflective material missing. 3

SOLUTION

Check for pin holes by holing CD up to a light source and observing it as illustrated.

• Defective CD should

not be used in CD Changer.

SYMPTOMS

CD loads, then ejects after a few sec- onds.

CAUSE

Rough edge. 5

SOLUTION

Rough edges may touch mechanism parts and can be corrected by lightly sanding CD edges.

16

Image 16
Contents Operating Instructions Contents Precautions Temperature Vehicle Precautions When Operating this ProductCompact Disc Type Keep Your CDS Clean Proper Care of Your CDsProper Handling Damaged CDSNever Attempt the Following Irregular Shaped CDSExplanation of the Hand Marks CD Changer OperationLoading the CD 1 Loading the CD con’t Insert the CD with the label side upSelecting a CD Ejecting the CD 1 Ejecting the CD con’t Illumination Installation Shipping BracketSymptom Cause Solution Initial Power UPCase of Difficulty Error Mode Indication Cause SolutionSolution SymptomsCause Switching the address setting Specifications