Fellowes 520C manual Maintenance Malfunctions, Checklist for Inoperative Machine

Page 7

 

520

Paper shredder

520C

 

 

Feeding continuous forms

Pass the leading edge of the form under the paper guide roller (1) and into the paper feed opening (2).

2

1

– Press green arrow button at least 4 sec

Cabinet door contact ajar / bag full

Red LED lights

• Shredder switches off automatically.

• Make sure cabinet door is properly closed and/or empty waste container.

– Press green arrow button at least 4 sec

9. Maintenance

8. Malfunctions

Paper jam

Red LED on keyboard lights

Shredder reverses automatically and runs in this mode for a few seconds.

Pull out jam and remove excess paper.

Caution!

Do not attempt to force the jammed material through the machine by alternating the cutting system between forward and reverse.

If paper jam cannot be removed

• Hold down reverse button until paper can be pulled out of the cutting system.

• Press green arrow button at least 4 sec

Continue shredding in smaller quantities so as not to jam the machine further.

or

Continue shredding in smaller quantities so as not to jam the machine further.

The shredding process is started by a photo–cell in the paper feeding opening

Electronic motor overheated

Red LED on keyboard lights

Shredder switches off automatically.

Allow shredder to cool down for approx. 15-20 min.

(Cross cut unit only)

When shredding capacity drops or the noise increases.

Apply oil over full width of cutting cylinders through the paper entry (Fellowes Powershred Lubricant

# 35250).

CAUTION: Do not use flammable synthetic oil, petroleum-based products, or aerosol lubricants of any kind.

• Run cutting system forward and back- ward several times without feeding paper.

Continue shredding.

10.Checklist for Inoperative Machine

If the equipment does not work properly, please check the following points first:

Is the plug inserted?

Is the switch turned on?

Is the cabinet door closed?

Is the waste receptacle full? Empty waste bag.

Is there a paper jam in the shredder? See Malfunctions

Is the motor overheated?

Switch machine off and allow motor to cool down for approximately 15-20 min.

If none of the above applies and the equipment still does not run, please contact our customer service department.

Edition 01/03

7

Image 7
Contents Powershred 520 520C Contents Parts Identification 520 520C Important Safety InstructionsTechnical Specifications Supplies Operation InstallationChecklist for Inoperative Machine Maintenance MalfunctionsContact for Service Warranty