Fellowes 72Ct manual Capabilities, Key, Basic Shredding Operation

A.

B.

C.

D.

CAPABILITIES

E.

F.

G

H.

ENGLISH

Model 72Ct

KEY

A. Paper entry	D. Window			H. Control Switch and Indicator lights
B. CD/Credit card	E. Disconnect power switch				R	1. Reverse
safety flap	1.		OFF		O	2. OFF
C. Pull-out Bin		2.	ON		I	3.	Auto-On (green)
	F. See safety instructions					4.	Turbo Jam Release™ (red)
	G. Handle					5.	Door Open (red)
						6.	Overheat (red)

Will shred: Paper, credit cards, staples, paper clips, CD/DVDs and junk mail.

Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper, cardboard, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:
Cross-Cut	4mm x 38mm

Maximum:
Sheets per pass	12*
Cards per pass	1*
Paper entry width	240mm

*A4 (70g), paper at 220-240V, 50/60 Hz, 2.2Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 800 sheets;

25 credit cards; 10 CDs. 12 sheets per pass.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

•Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.

•Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.

•Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.

•Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.

•Do not use if damaged or defective. Do not disassemble shredder.

Do not place near or over heat source or water.

•This shredder has a Disconnect Power Switch (E) that must be in the ON ( ) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.

•Avoid touching exposed cutting blades under shredder head.

•Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.

•FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.

•For indoor use only.

•Unplug shredder before cleaning or servicing.

BASIC SHREDDING OPERATION

Continuous operation: Up to 20 minutes maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 20 minutes will trigger 40-minute cool down period.

PAPER, CARD or CD
1	2	3	4	5	6
			or
Plug in and put	Set to Auto-On (I)	Feed paper straight	To shred CDs or credit	Hold card/CD at	When finished
disconnect power		into paper entry	cards rotate safety flap	edge, feed into	shredding set to
switch in ON (I) position		and release	into place	card/CD flap entry	OFF (O)
				and release