Fellowes DS-700 manual Basic Shredding Operation, Troubleshooting, Shredder doesn’t start

Page 3

BASIC SHREDDING OPERATION

Continuous operation: Up to 5 minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 5 minutes will trigger a

20-minute cool down period.

PAPER/CARD

 

 

 

1

2

3

4

Plug in and put

Set to Auto-On (I)

Feed paper/card

When finished shredding

disconnect power

 

straight into paper

set to OFF (O)

switch in ON (I) position

 

entry and release

 

Safety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide towards front of shredder. To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.

TROUBLESHOOTING

PAPER JAM

1

2

3

4

5

6

Set to Reverse (R)

Alternate slowly back and forth

Set to Off (O)

Gently pull uncut

Set to Auto-On

for 2-3 seconds

 

and unplug

paper from paper

(I) and resume

 

 

 

entry. Plug in.

shredding

Shredder doesn’t start:

Make sure bin is pushed in

Wait 20 minutes for motor to cool down Remove and empty basket

Make sure safety lock is in unlock position

PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

 

1

2

3

Set to Off (O)

*Apply oil

Set to Reverse (R)

 

across entry

2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

LIMITED PRODUCT WARRANTY

Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 1 year from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 3 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any

additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

Australia Residents Only:

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits under Fellowes’ Warranty are in addition to other rights and remedies under a law in relation to the shredder.

Image 3
Contents Powershred DS-700C Maximum CapabilitiesKEY Paper shred sizeTroubleshooting Basic Shredding OperationShredder doesn’t start Questions or Concerns?