Fellowes PS-12Cs Basic Shredding Operation, Advanced Product Features, Basic Product Maintenance

BASIC SHREDDING OPERATION

Continuous operation:

4-5-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 4-5-minutes will trigger

20-minute cool down period.

PAPER/CARD
1	2	3	4	5	6
			OR
Set to Off (O)	Press Auto-On ( I )	Feed into paper	Hold card at edge	Feed into center of	Set to Off (O)
		entry and release		entry and release

ADVANCED PRODUCT FEATURES

SAFESENSE® TECHNOLOGY OPERATION

Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING

1 2

3

Press Auto-On (I)	Touch test area and	SafeSense® is active and
	look for the SafeSense®	working properly
	indicator to illuminate

BASIC PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

1 2 3

Set to Off (O)	*Apply oil	Set to Reverse (R)
	across entry	2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.

B.SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate

A		B	and the shredder will stop shredding.
PAPER JAM
1	2	3	4	5	6

Set to Reverse (R)	Alternate slowly back and forth	Set to Off (O)	Pull uncut paper from	Set to Reverse (R)
		and unplug	paper entry

3