BASIC SHREDDING OPERATION
Shredder comes fully assembled. Remove basket packaging material and
Continuous operation:
NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond
PAPER OR CARD |
|
|
|
|
|
1 | 2 | 3 | 4 | 5 | 6 |
|
|
| OR |
|
|
Set to Off (O) | Press | Feed into paper | Hold card at edge | Feed into center of | Set to Off (O) |
|
| entry and release |
| entry and release |
|
TO TEST SAFESENSE® TECHNOLOGY
1 | 2 | 3 |
Press | Touch test area and | Sensor lights up |
| look for the SafeSense® |
|
| indicator to illuminate |
|
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
1 | 2 | 3 | 4 | 5 | 6 |
Set to Reverse (R) | Alternate slowly back and forth | Set to Off (O) | Pull uncut paper from | Set to Reverse (R) |
|
| and unplug | paper entry |
|
ATTENTION: If the SafeSense® light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense® feature. (See SafeSense® instructions below.)
Shredder doesn’t start:
Yellow - SafeSense® active
Yellow flashing - SafeSense® not active
Make sure control switch is in
Wait 20 minutes for red light to turn off
SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense® feature and clear the paper. Warning – when switch is in override position, the SafeSense® light will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature.
Sensor light
SafeSense® override switch
Active | Not active |
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE |
| |
1 | 2 | 3 |
Set to Off (O) | *Apply oil | Set to Reverse (R) |
| across entry |
*Only use a
2