Advanced Product Features, Product Maintenance

BASIC SHREDDING OPERATION

Continuous operation:

Up to 5-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 5-minutes will trigger 20-minute cool down period.

PAPER/CARD
1	2	3

Plug in and put	Press Auto-On ( )	Feed paper/card
disconnect power switch		straight into paper
in ON (I) position		entry and release

When finished shredding, set to Off

ADVANCED PRODUCT FEATURES

SAFESENSE® TECHNOLOGY

Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING

1 23

Press Auto-On ( )

Touch test area

Sensor lights up

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

CLEANING AUTO-START INFRARED SENSORS

Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present.

(Note: two paper detection sensors are located in the center of the paper entry).

TO CLEAN THE SENSORS

1 2 3

Set to Off	*Apply oil	Press and hold Reverse
	across entry	(R) 2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

1 23

Turn off and unplug	Locate Auto-start	Dip cotton swab in
shredder	infrared sensor	rubbing alcohol

Using cotton swab, wipe away any contamination from the paper sensors

TROUBLESHOOTING

PAPER JAM
1	2	3	4	5	6

Press and hold	Alternate slowly back and forth	Set to Off (O)	Gently pull uncut	Press Auto-On (	)
Reverse (R)		and unplug	paper from paper	and resume shredding
2-3 seconds			entry. Plug in

Shredder doesn’t start:

Yellow - SafeSense® active

Yellow flashing - SafeSense® not active

Make sure head is on basket correctly

Wait 20 minutes for motor to cool down

Remove and empty basket

ATTENTION: If the SafeSense® light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense® feature. (See SafeSense® instructions below.)

SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think the shredder has jammed when it has not, use theOverride Switch to deactivate the SafeSense® feature and clear the paper. Warning – when switch is in override position, the SafeSense® light will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature.