Fellowes P-58Cs To Test SafeSense Technology, Important Safety Instructions Read Before Using

ENGLISH

	Model P 58Cs
Disconnect power switch
SafeSense® Technology	See safety instructions below
Shredder head	Paper/credit card entry
Sheet capacity icon	SafeSense® (yellow)

OPERATION

Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.

PAPER

LED Lights	Sheet capacity gauge
Standby (green)
	Control switch
Overheated (red)
	Auto-On (I)
	Off (O)
	Reverse (R)
Bin

Continuous operation:

3-5 minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond

3-5 minutes will trigger 15-minute cool down period.

	Check paper amount	Set to Auto-On (l)	Feed into paper entry
Set to Off (O)			and release	Set to Off (O)
and plug in	CARD/CD			and unplug

Set to Auto-On (l)	Hold card at edge	Feed into center of entry
		and release

SafeSense® Override Switch

Active Not active

Breakthrough Safety Technology! SafeSense® stops shredding when hands are too close to the opening.

To Test SafeSense® Technology

Press Auto-On (I) Touch test area Sensor lights up

TROUBLESHOOTING

Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.

Set to Reverse (R)	Alternate slowly back and forth	Set to Off (O)	Gently pull uncut paper	Set to
for 2-3 seconds		and unplug	from paper entry. Plug in.	Reverse (R)

Indicator lights:

Yellow - SafeSense® active

Yellow flashing - SafeSense® not active Make sure head is on basket correctly Wait 15 minutes for motor to cool down Remove and empty basket

CAPABILITIES

ATTENTION: If the SafeSense® light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense® feature. (See SafeSense® instructions below.)

Sensor light illuminated–paper jammed

SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think

Will shred: Paper, credit cards, staples

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, paper clips, laminates or plastic other than

noted above

Maximum:	9*
Sheets per pass
Cards per pass	1*
Paper width	8 3/4” (225mm)
Continuous operation	3-5 minutes

the shredder has jammed when it has not, use theOverride Switch to deactivate the SafeSense® feature and clear the paper. Warning – when switch is in override position, the SafeSense® light will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature.

SafeSense® override switch

Paper shred size:

Cross-Cut 5/32” x 2” (3.9 x 50mm)

*20 lb., 8.5”x11” paper at 120v, 60Hz, 3.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 10-20 paper passes; 10 cards.

Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

MAINTENANCE

Run regularly in reverse for one minute

Active Not active

Follow oiling procedure below and repeat twice.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

Oil when bin is full, or immediately, if:

•Capacity decreases

•Motor sounds different, or Shredder stops running

Set to Off (O)	*Apply oil	Set to Auto-On (I)	Shred one sheet	Set to Reverse
	across entry			(R) 2-3 seconds

•Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair, etc.– away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.

• Avoid touching exposed blades under Cross-Cut shredder head.

2

• Never use aerosol, petroleum-based or other flammable products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source.

• 9 sheets per pass to avoid jams.

•The grounded socket-outlet shall be installed near the equipment and shall be easily accessible.

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY defects in material and workmanship for 5 years from the date of purchase by the original consumer. LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall

Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 2	Fellowes be liable for any consequential or incidental damages attributable to this product.
years from the date of purchase by the original consumer. If any part is found to be defective during the	This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and	worldwide, except where different limitations, restrictions, or conditions may be required by local law.
expense, of the defective part.	For more details or to obtain service under this warranty, please contact us or your dealer.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED

5