Fellowes 320, 320C, 320-2HS, 380, 380C Checklist for Inoperative Machine, Malfunctions, Paper jam

	320
	320C	380
Paper shredder	320-2HS	380C

8. Checklist for Inoperative Machine

If the equipment does not work properly, please check the following points first:

–Is the plug inserted?

–Is the switch turned on?

–Is the cabinet door closed?

–Is waste receptacle full? Empty waste bag.

–Is there a paper jam in the shredder?

–Is the motor overheated?

Switch machine off and allow motor to cool down for approximately 15–20 min.

Door contact ajar / bag full

Red LED lights

– Paper shredder switches off automatically.

2 • Press rocker switch to center position (2).

•Make sure cabinet door is properly closed and/or exchange cut material bag.

1

• Return switch to "on" position (1) and continue shredding

If none of the above applies and the equipment still does not run, please contact our customer service department.

9. Malfunctions

Paper jam

• Press rocker switch to center position (2)

2

to stop the cutting system

• Press and hold down rocker switch in

10. Maintenance

(Cross cut unit only)

–When shredding capacity drops or the noise increases.

•Apply oil over full width of cutting cylinders through the paper entry (Fellowes Powershred Lubricant

# 35250).

CAUTION: Do not use flammable synthetic oil, petroleum-based products, or aerosol lubricants of any kind.

3

pos. 3 to reverse the cutting system and back out jammed material

(paper is pushed out)

1 • Run cutting system forward and back-

3

ward several times without feeding paper.

Caution!

1Do not attempt to force the jammed

• Continue shredding.

3

material through the machine by alternating the cutting system between forward and reverse

• Remove excess paper

1 • Return switch to pos. 1 and continue shredding in smaller quantities so as not to jam the machine further

Note:

The 320-2HS will not run forward again unless the jammed material has been completely removed from the throat

Edition 01/03 7