3. Using the Keyboard and Mouse
This wireless keyboard and mouse combo consists of a receiver that plugs into the computer, a wireless keyboard, and a wireless mouse.
3.1 Hardware Installation
3.1.1 Getting the Receiver Ready
Connect the receiver and select a wireless channel:
1.Make sure your PC is switched off.
2.Turn the receiver over and find the channel slide switch. Select either channel CH1 or CH2. Remember which channel you selected.
Bottom View of Receiver | Receiver Channel Slide Switch |
3. Connect the receiver to your PC by plugging the receiver's USB connector into your PC.
USB Connector
4.Set the receiver on a flat surface and follow these guidelines:
a.There should be a minimum of 8 inches clearance between the receiver and other electronic devices.
b.There should be a minimum of 8 inches clearance between the receiver and the monitor.
c.The distance between the receiver and the wireless mouse or keyboard should not exceed 4.92 feet.
d.For better reception, the receiver works best on a nonmetallic surface.
3.1.2Getting the Keyboard Ready
Install the two AA alkaline batteries (provided) into the keyboard and select a wireless channel:
1.Turn the keyboard over and find the battery compartment. Lift the cover.
2.Insert the included AA alkaline batteries into the compartment. Make sure the batteries are placed in the correct direction by following the polarity signs in the battery compartment.
Channel Slide Switch
Battery Compartment
Bottom View of Keyboard
2