Guided Tour Front Panel | Samson KM60, 100 instruction

Guided Tour - Front Panel

�	�	�	�	�	�	�	�	�
								�
								�

1.Channel 1 MIC IN - XLR input connector for connecting to Channel 1’s Low-noise Microphone Pre-amp.

2.AUX IN/CD - Your KM Series amplifier features a CD input which you can use with a por- table CD player, cassette, mini disk or MP3 player. You can use the CD input to jam with pre- recorded tracks or to learn a riff from a favorite recording.

3.Channel 1 Volume - Control knob is used to control the overall level of the Channel 1 input.

4.Channel 2 Volume – This control knob used to control the overall level of the Channel 2 input.

5.Channel 3 Volume - Control knob is used to control the overall level of the Channel 3 input.

6.Channel 4 Volume – This control knob is used to control the overall level of the Channel 4 input.

7.Graphic Equalizer - These sliders allow you to “draw” the tonal response of the system by adding 12 dB of boost or attenuation to seven different narrow-band frequency areas (100 Hz, 250 Hz, 500 Hz, 1 kHz, 2.5 kHz, 5 kHz, and 10 kHz), affecting the main output signal of the KM100. When a slider is at its center detented (“0”) position, the selected frequency area is unaffected (it is said to be flat). When a slider is moved up (above the “0” position, towards the “+12” position), the selected frequency area is boosted, and when it is moved down (below the “0” position, towards the “-12” position), the selected frequency area is attenuated. For more information, see the “About Equalization” section on pages 9 - 10 of this manual.

8.Volume - Control knob used to control the overall level the KM60 or KM100 amplifier.

9.Power switch - Use this to power the KM60 or KM100 on or off.

KM60100_ownman_v1.indd 4

11/21/05 10:38:38 PM