Location and Function of Controls
Rear panel
R/G/B VIDEO IN connectors
LANDING SENSOR connector
I/F connector
MAIN circuit breaker
HD input connector VD input connector POWER indicator FAILURE indicator ROTATION control
AC IN socket
1 R/G/B VIDEO IN (input) connectors (BNC type) | 7 POWER indicator (green) |
Inputs the R (red), G (green) and B (blue) signals. The connectors are terminated at 50 ohms.
Lights when the POWER switch on the front panel is turned on.
2LANDING SENSOR connector (8 pin)∗
This connector is used when adjusting uneven color by connecting the optional
3I/F (interface) connector (D-sub 15 pin)∗
This connector is used when externally controlling brightness, contrast, etc., and adjusting distortion, convergence, color temperature, etc. by connecting the optional
∗Adjustments 2 and 3 are performed by a service engineer. Should the adjustment be required, please consult a Sony representative.
4MAIN circuit breaker
Set this circuit breaker to the I (on) position when using this unit.
5HD (horizontal drive) input connector (BNC type)
Inputs horizontal drive pulses (HD). The connector is terminated at 75 ohms.
6VD (vertical drive) input connector (BNC type)
Inputs vertical drive pulses (VD). The connecter is terminated at 75 ohms.
8FAILURE indicator (red)
Lights when the circuits inside the unit are not functioning correctly. Should this lamp light, turn off the MAIN circuit breaker and consult a Sony representative.
9ROTATION CONTROL
Adjusts the picture rotation. Use a screwdriver etc. to turn the control.
Rotate the picture | Rotate the picture |
clockwise | counterclockwise |
0AC IN socket
Connect an AC power cord here.
Note
When connection to 1, 5 and 6, use a
4