Sony PCV-RZ40, VAIO DIGITAL STUDIO quick start FCC Part

Page 7

FCC Part 68

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the modem card is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.

This modem uses the USOC RJ-11 telephone jack.

A telephone plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. The REN is used to determine the quantity of devices which may be connected to the telephone line.

Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the telephone company. For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the format US:AAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g. 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.

If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operations of the equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modifications in order to maintain uninterrupted service.

If trouble is experienced with this equipment, for repair or warranty information, please contact the Sony Customer Information Service Center at 1-888-4-SONY-PC (1-888-476-6972), or write to the Sony Customer Information Center, 12451 Gateway Blvd., Fort Myers, FL 33913, or find Sony Customer Service on the Web at http://www.sony.com/pcsupport. If this equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment from the network until the problem is resolved.

Repair of this equipment should be made only by a Sony Service Center or Sony authorized agent. For the Sony Service Center nearest you, call 1-888-4-SONY-PC (1-888-476-6972), or visit the Sony Computing Web site at http://www.sony.com/pcsupport.

Connection to Party Line Service is subject to state tariffs. Contact the state public utility commission, public service commission, or corporation commission for information.

If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer.

Please use a surge arrestor against electrical surges.

7

Image 7
Contents Vaio Digital Studio Computer Quick Start Page Owner’s Record Safety Information and Caution Page Regulatory Information FCC Part Telephone Consumer Protection Act of 1991 United States Industry Canada Notice Page Contents Using the Sound Blaster Audigy ES Sound Card Getting Started Unpacking your Computer Computer and supplied accessoriesManuals Online Documentation Hard Disk Drive RecoveryOther Vaio Digital Studio Computer Quick Start Locating Controls And Ports Floppy disk drive About the Front PanelFront panel Optical driveStand by indicator Floppy disk drive access indicatorPower indicator Power switchSmartMedia media slot Memory Stick media slot and access indicatorUniversal Serial Bus USB 2.0 ports Mouse port About the Back PanelBack panel AC Input portTelephone jack Printer portLink 6-pin S400 port Ieee Monitor portSub-woofer unit About the Sub-WooferFunction Volume ControlAbout the Keyboard Vaio KeyboardApplications StandbyDirectional ArrowsVaio Digital Studio Computer Quick Start Setting Up Your Computer To connect a display Connecting a Display MonitorTo connect a DVI display To connect the computer and speakers Connecting the Speakers and Sub-woofer UnitTo connect the sub-woofer unit and speakers To connect the sub-woofer to the computer To use an optical mouse Connecting the Keyboard and MouseTo connect the keyboard and mouse To connect the telephone and modem cables Connecting the Telephone and Modem cablesTo connect the power cords Connecting the Power CordsRegistering your Computer Turning On your ComputerTo turn on your computer Turning Off your Computer About the power buttonTo turn off your computer Vaio Digital Studio Computer Quick Start Audigy ES Sound Card Installing from the Sound Blaster Audigy CD Installing Sound Blaster Audigy SoftwareCreative software programs partial list detail Starting Creative softwareAbout Creative Software Programs About Creative Software Programs Vaio Digital Studio Computer Quick Start My computer does not start TroubleshootingWhy did my computer or software stop responding? Advanced Controls for Play Control dialog box appears Vaio Digital Studio Computer Quick Start Immediate Help and Support Support OptionsSony Online Support Web site Resources for Additional Help and SupportClick Welcome to Vaio Life Sony Customer Information Services Center Sony Electronics Inc
Related manuals
Manual 94 pages 57.08 Kb