Dell 760N, 720N, 740N, 2385P manual 8VLQJWKHSLQJ&RPPDQG, 3URFHGXUH

5HVXOWV

After you finish configuring the filer, it is on-line. The following directories exist on the filer:

/vol/vol0

/vol/vol0/home

NOTE: /vol￿is not a directory—it is a special virtual root path under which the filer mounts its volumes. You cannot mount /vol￿to view all the volumes on the filer; you must mount each filer volume separately.

If you purchased a license for the NFS protocol, /vol/vol0 is exported to the administra- tion host for root access; /vol0/home is exported to the administration host for root access and to all clients for general access.

If you purchased a license for the CIFS protocol, /vol/vol0 is shared as C$; only the system administrator with the root password has read and write access to the C$ share. The /vol/vol0/home directory is shared as HOME without access granted to anyone.

9HULI\LQJ￿1HWZRUN￿&RQQHFWLRQV

8VLQJ￿WKH￿SLQJ￿&RPPDQG

After you configure the filer, you use the ping command from a client attached to the network to verify that the filer can communicate with other computers on the network.

3URFHGXUH

To verify filer communication, perform the following steps:

1.At a client attached to the network, enter the following command: ping hostname-interface

Replace the variable hostname with the host name that you assigned to the filer when you ran setup; replace the variable interface with one of the interface names that the filer assigned when you ran setup.

2.Repeat the test once for each interface that is installed in the filer.

([DPSOHV

The following examples test the network connections for a filer that has the host name filer with two interfaces named e0 and f0 installed:

ping filer-e0

ping filer-f0

4-4 Dell PowerVault 720N, 740N, and 760N User’s Guide