WARNING
LAN Configuration
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and you will not be able to connect to your N8800 after Jumbo Frame is turned on. If this happens, turn off the N8800. Then, power on the N8800 and immediately press and hold the Reset button on the back of the unit for 10 seconds. This will reset your network settings, password, and turn off Jumbo Frame Support.
The N8800 supports two Gigabit Ethernet ports for higher service availability. To configure these ports, choose LAN from the Network menu, and the LAN Configuration screen appears. Press Apply to save your changes.
LAN Configuration
Item | Description |
MAC Address | Displays the MAC address of the LAN interface. |
IP | Specifies the IP address of the LAN interface. |
Netmask | Specifies the Network Mask of the LAN interface. |
Jumbo Frame Support | Enable or disable Jumbo Frame Support on the LAN interface. |
NOTE
Before enabling Jumbo Frame Support, please make sure your network equipment supports Jumbo Frame. If your equipment is incompatible, you might not be able to connect to your N8800. In this case, you have to reset the system back to default by the holding down front panel reset button for 5 seconds during boot up process.
DHCP Configuration
A DHCP server can be configured to assign IP addresses to devices connected to the LAN port. To configure these ports, choose LAN from the Network menu.
DHCP Configuration
Item | Description |
DHCP Server | Enable or disable the DHCP server to automatically assign IP |
| address to PCs connected to the LAN interface. |
Start IP | Specifies the starting IP address of the DHCP range. |
End IP | Specifies the ending IP address of the DHCP range. |
DNS Server | Displayed the DNS server IP address. |
NOTE
WARNING
The IP Segment of WAN and LAN should not overlap.
The IP address of the LAN interface should not be in the range of the Start IP address and End IP address.
47