Network Computing Devices WUSB11 manual Proceed to Hardware Installation

Page 8

Instant Wireless® Series

4.If you chose Infrastructure Mode, go to Step 5 now. If you chose Ad-Hoc Mode, select the correct operating channel for your network. The channel you choose should match the channel set on the other devices in your wire- less network. Then click the Next button.

Figure 4-4

5.The Setup Wizard will ask you to review your settings before it starts to copy files. Click the Next button to save these settings, or click the Back button to change any settings.

Figure 4-5

Wireless USB Network Adapter

6.After the software has been successfully installed, the screen in Figure 4-6 will appear. Click the Exit button.

Figure 4-6

Proceed to “Chapter 5: Hardware Installation.”

8

9

Image 8

Contents Wireless USB Network Adapter Copyright & Trademarks Table of Contents Introduction Wireless USB Network AdapterFeatures Network Topology Planning Your Wireless NetworkAd-Hoc versus Infrastructure Mode Overview Getting to Know the Wireless USB Network AdapterWireless USB Network Adapter’s Port and LEDs Instructions for Windows 98SE, Me, Proceed to Hardware Installation Using the Adapter’s Wall Mount Hardware InstallationConnecting the Adapter Step B Driver Installation and Configuration for Windows XP Driver Installation for Windows XPWindows XP Wireless Zero Configuration Accessing the Wlan Monitor Link InformationWireless Network Status Site SurveyProfiles Profile InformationCreating a New Profile Instant Wireless Series Instant Wireless Series Frequently Asked Questions Appendix a TroubleshootingCommon Problems and Solutions What is the Ieee 802.11b standard? Can Instant Wireless products support printer sharing? Appendix B GlossaryInstant Wireless Series Instant Wireless Series Appendix C Specifications EnvironmentalAppendix D Warranty Information Appendix E Contact InformationCopyright 2003 Linksys, All Rights Reserved