CONNECTING YOUR MONITOR : ProLite E2201W
AEnsure that both the computer and the monitor are switched off.
BConnect the computer to the monitor with the signal cable. (See page 32 for CONNECTOR PIN ASSIGNMENT.)
CConnect the Power Cable to the monitor first and then to the power supply.
NOTE The signal cables used for connecting the computer and monitor may vary with the type of computer used. An incorrect connection may cause serious damage to both the monitor and the computer. The cable supplied with the monitor is for a standard 15 pin
For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama office for a suitable adaptor.
Make sure you tighten the finger screws at each end of the signal cable.
[Example of Connection]
<Back>
ENGLISH
Power Cable | ||
(Accessory) | ||
(Accessory) | ||
|
Computer
[ Fitting of Cable Holder ]
ACollect cables at the back of the stand.
BPosition the Cable Holder at the base of the stand column by inserting the ‘tabs’ into the guide holes. Apply gentle pressure downwards to secure.
[ Removal of Cable Holder ]
ARemove Cable Holder by sliding up the base column.
Ãáâìå Èïìäåò
Stand
BEFORE YOU OPERATE THE MONITOR 9