Iiyama E1908WSV user manual Fitting and Removal of Base, Install

Page 9

FITTING AND REMOVAL OF BASE

CAUTION „ Install the stand on a stable surface. The monitor may cause injury or damage if it falls or is dropped.

„Do not give a strong impact to the monitor. It may cause damage.

„Unplug the monitor before installation to avoid electric shock or damage.

<Install>

1.Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay the monitor flat on a table with front face down.

2.Hold the monitor and push the Stand-Arm. 3.Hold the monitor and push the Stand-Base.

Stand-Arm

<Remove>

1.Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay the monitor flat on a table with front face down.

2.Press the stopper at the bottom of the stand and remove the Stand-Base from the arm.

3.Press the stopper at the back of the stand arm and remove the Stand-Arm from the monitor.

Stopper

Stand-Base

Stopper Stand-Arm

ENGLISH

Stand-Base

BEFORE YOU OPERATE THE MONITOR 5

Page 8 Page 10
Image 9
Page 8 Page 10
Contents English Deutsch Francais Nederlands Iiyama Servicecard CE Marking Declaration of Conformity Table of Contents Safety Precautions For Your SafetyDo not Touch the Plug with WET Hands Customer Service CleaningSpecial Notes on LCD Monitors Features Checking the Contents of the PackageBefore YOU Operate the Monitor Fitting and Removal of Base InstallControls and Connectors Sub Signal Cable Accessory Audio Cable Accessory Computer Adjusting the Viewing Angle Computer SettingOperating the Monitor Adjustment Menu Contents N u Menu Is displayed while Economy Mode is active STD DCR Screen Adjustments English English Power Management Feature Problem Check Trouble ShootingLoud or too quiet Monitor Appendix SpecificationsCompliant Timing Dimensions
Top Page Image Contents