Daily use | 3 |
When you have finished setting up the loudspeakers as described on the following pages, connect the entire system to the mains supply. The indicator lights up in red, indicating that the loud speakers are in standby, ready to be used. The loudspeakers are designed to be left in this standby mode when not in use.
Switching on and off – indicator
When you switch on your Bang & Olufsen system, the loudspeakers switch on simultaneously. The red standby indicator light turns green, indicating that the loudspeakers are switched on.
When you switch off your system, or mute the sound, the red indicator light appears immediately, indicating that the loudspeakers are not in use.
If the loudspeakers are connected to a
p. 6). They switch off a few minutes after the signal has disappeared.
Loudspeaker protection
The loudspeakers are equipped with a thermal protection system which prevents overheating. If an error occurs – or the speaker units
become overheated – the system automatically switches the loud speakers to standby, and the indicator light turns orange.
To restore the situation:
>Disconnect the loudspeakers from the mains.
>Allow the system time to reset (approximately
>Reconnect the loudspeakers to the mains.
Should the problem persist, contact your Bang & Olufsen retailer.
Indicator
Cleaning the loudspeaker
Wipe dust off the surfaces using a dry, soft cloth. If necessary, remove stains or dirt with a soft, damp cloth and a solution of water and mild detergent such as
Never use alcohol or other solvents to clean any part of the loud speakers!
NOTE! Prolonged listening at high volume levels may cause hearing damages.