NDC comm Instant Wave manual Trademarks

Page 2

TRADEMARKS

NDC and InstantWave are trademarks of National Datacomm Corporation. All other names mentioned in this document are trademarks/registered trademarks of their respective owners.

NDC provides this document “as is”, without warranty of any kind, neither expressed nor implied, including, but not limited to, the particular purpose. NDC may make improvements and/or changes in this manual or in the product(s) and/or the program(s) described in this manual at any time. This document could include technical inaccuracies or typographical errors.

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation

iiInstantWave High Rate Access Point

Page 1 Page 3
Image 2
Page 1 Page 3
Contents
11Mbps Wireless Networking Access Point User’s GuideTrademarks Table Of Contents Upgrade AP Firmware Reset AP Configuration Simple Wireless Infrastructure Network List of FiguresPacking List System Requirements IntroductionInstantWave High Rate Family CablingGlossary Group ID/BSSIDHow to Use this Guide Planning Your Network Infrastructure Network TypesAP to Wired Ethernet Bridge Planning an Infrastructure Network Single AP InstallationMultiple AP Installation Roaming Mounting the AP Access Point Placement GuidelinesPlacement Tools Placing For PerformanceGetting Started Access Point Hardware InstallationLED Indicators AP Management Software Installation/Uninstallation InstallationUninstalling AP COMFig Tool Using the AP COMFig ToolAP COMFig Password AP COMFig Service GeneralBSS ID Channels supported on each carrier set Disabled default Filter Reset AP Configuration Perform AP Self Diagnostic TestUpgrade AP Firmware Trouble Shooting Operational ProblemsInstantWave High Rate Access Point Technical Support NDC Limited Warranty HardwareLimited Warranty Service Procedures Limitation of Liability EC Declaration of Conformity Index Alias nameSnmp
Top Page Image Contents