Hanns.G HG281 manual Special Notes On Lcd Monitors, Lamp Disposal, User’s Manual

Page 7
SPECIAL NOTES ON LCD MONITORS

User’s Manual

SPECIAL NOTES ON LCD MONITORS

The following symptoms are normal with LCD monitor and do not indicate a problem.

Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears.

You may find slightly uneven brightness on the screen depending on the desktop pattern you use.

The LCD screen has effective pixels of 99.99% or more. It may include blemishes of 0.01% or less such as a missing pixel or a pixel lit all of the time.

Due to the nature of the LCD screen, an afterimage of the previous screen may remain after switching the image, when the same image is displayed for hours. In this case, the screen is recovered slowly by changing the image or turning off the Power Switch for hours.

If the screen suddenly flashes erratically or the backlighting fails, please contact your dealer or service center for repair. Do not attempt to repair the monitor yourself.

Lamp Disposal

LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE ELECTRONIC INDUSTRIES ALLIANCE AT WWW.EIAE.ORG. FOR LAMP SPECIFIC DISPOSAL INFORMATION CHECK TTTTWWW.LAMPRECYCLE.ORG.

7

Image 7
Contents HSG1040 HG281User’s Manual FCC Class B Radio Frequency Interference StatementEmissions CongratulationsErgonomics EnergyRecycling Information GENERAL INSTRUCTIONS TABLE OF CONTENTSMAKING CONNECTIONS OPERATING INSTRUCTIONSPRECAUTIONS SAFETY NOTICELamp Disposal SPECIAL NOTES ON LCD MONITORSCHECKING THE CONTENTS OF THE PACKAGE FEATURESBEFORE OPERATING THE MONITOR POWER SOURCE INSTALLATION INSTRUCTIONSPOWER INSTALLATIONMAKING CONNECTIONS CONNECTING TO A PCCONNECTING TO A A/V DEVICE ADJUSTING THE VIEWING ANGLE GENERAL INSTRUCTIONS OPERATING INSTRUCTIONSAdjust FRONT PANEL CONTROLPower Button Power IndicatorIMAGE SETTING HOW TO ADJUST A SETTINGSINPUT SETTING COLOR SETTINGInput only OSD SETTINGonly For VGA onlyWhile transferring via the HDMI port, it is recommended to set SYSTEMAUDIO IN port. For HDMI Input only Dual input mode optionalPLUG AND PLAY Plug & Play DDC2B Feature Q & A FOR GENERAL PROBLEMS TECHNICAL SUPPORT FAQNo sound is outputted from monitor’s built-in speaker YPbPr mode ERROR MESSAGE & POSSIBLE SOLUTIONSRECOMMENDED AND SUPPORTED TIMING MODE Analog / Digital modeAPPENDIX SPECIFICATIONS
Related manuals
Manual 20 pages 35.13 Kb