Tips for Successful Vacuum Packaging
For more usage tips and safety information, please refer to the FoodSaver Reference Guide or visit our website at www.foodsaver.com.
Tips for Successful Vacuum Packaging
(continued)
QuickStart
V875
Sealing a Bag
General Tips
Make sure you’ve placed the bag in the proper
place. When making a bag from a roll, make sure end of cut piece is on Sealing Strip (K), not over rubber gasket (L) or in Vacuum Channel (I).
Prevent moisture or liquid from being pulled into the Vacuum Channel or trapped in the seal. Either
3 inches between paper towel and end of bag so that bag seals properly with paper towel inside.
Make sure the Seal Control Switch (E) is set to Vacuum and Seal.
Make sure you give appliance time to cool down.
Wait at least 20 seconds between seals. Under very heavy usage, appliance will shut off automatically to prevent overheating. If it does, wait 20 minutes to allow appliance to cool off.
1. | Vacuum packaging is NOT a substitute for the |
| heat process of canning. Perishables still need to |
| be refrigerated or frozen. |
2. | For best results, use FoodSaver Bags, Canisters |
| and Accessories. |
3. | During the vacuum packaging process, small |
| amounts of liquids, crumbs or food particles can |
| be inadvertently pulled into Vacuum Channel, |
| clogging the pump and damaging your appliance. |
| To prevent this, follow these tips: |
| a. For moist and juicy foods such as raw meats: |
| Freeze first and avoid overfilling bags. You can |
| also place a folded paper towel inside top of bag, |
5. | Do not create your own side seams for a |
| FoodSaver Bag. These bags are manufactured |
| with a special side seam, which is sealed all the |
| way to the outer edge. |
6. | To prevent wrinkles in seal when vacuum |
| packaging bulky items, gently stretch bag flat |
| along Sealing Strip before you close lid. |
7. | If you are unsure your bag was sealed properly, |
| simply reseal bag about 1⁄4 inch above first seal. |
8. | When you are vacuum packaging items with sharp |
| edges (dry spaghetti, silverware, etc.), protect |
| bag from punctures by wrapping item in soft |
Features of Your FoodSaver Appliance
A Instant Seal Button
B Cancel Button
C Accessory Port
D Indicator Light
E Seal Control Switch
Removing Air from a Bag
Make sure you’ve placed the bag in the proper
place. When vacuuming and sealing a bag, make sure open end of bag is inside Vacuum Channel.
Check for wrinkles in the bag along the Sealing
Strip. Wrinkles in seal may cause leakage and allow air to come back into bag. Check for wrinkles in bag along Sealing Strip before closing lid and vacuum packaging. If you find wrinkles after sealing bag, simply cut bag open and vacuum package again.
If motor runs for more than 30 seconds without
stopping, you may need to adjust bag and try again. If you are making the initial seal on a piece of bag material with two open ends, make sure bag is placed on Sealing Strip, not on black rubber gasket. If you are vacuum packaging with a bag, make sure open end is placed down inside Vacuum Channel and make sure Accessory Hose is not attached. If you are vacuum packaging with an accessory, check Accessory Hose in appliance lid and in accessory to ensure a tight fit. Also make sure Seal Control Switch (E) is set to Vacuum and Seal or Vacuum and Extended Seal.
but below seal area, before vacuum packaging. |
b. For soups, sauces and liquids: Freeze first and |
avoid overfilling bags. Or, use a canister in |
refrigerator. |
c. For powdery or |
overfilling bags or use a canister. You can also |
place a coffee filter or paper towel inside |
before vacuum packaging. |
d. If your appliance features a Drip Tray, empty it |
after each use. |
4. To avoid overfilling, always leave at least 3 inches |
of bag material between bag contents and top of |
bag. Then leave at least one additional inch of bag |
material for each time you plan to reuse bag. |
cushioning material, such as a paper towel. You |
may want to use a canister or Mason jar instead |
of a bag. |
9. When using accessories, remember to leave one |
inch of space at top of canister or container. |
10. |
vacuum packaging for best results. See pages |
of FoodSaver Reference Guide for more information. |
F Bag Cutter
G Accessory Hose
H Roll Storage
Compartment
Tips
Copyright © 2006 Tilia, Inc. All rights reserved. This material may not be reproduced or redistributed in any fashion without the express written consent of Tilia, Inc. FoodSaver and the Freshness Shield logo are trademarks or registered trademarks of Tilia Int’l, Inc. in the United States and other countries. All other trademarks are property of their respective owners. Tilia, Inc. and Tilia Int’l, Inc. are Jarden companies.This product is protected by one or more of the following Patents:
U.S. 4,660,355; 4,941,310; 5,655,357; 6,058,998; 6,256,968; Canada 1,315,746; and their equivalent international patents.
Item #
I Vacuum Channel
J Drip Tray
K Sealing Strip
L Rubber Gasket
For important safety information and helpful tips, please refer to the FoodSaver Reference Guide included in your kit. Questions? Visit us at www.foodsaver.com or call