PO Rtant SAF ETY I N STR U CTI O N S | Furman Sound PL-8 PRO II

pro SERIES II 20 amp Power ConditionerS

WA R N I N G

To reduce the risk of electrical shock, do not expose this equipment to rain or moisture. Dangerous high voltages are present inside the enclosure. Do not remove the covers. Refer servicing to qualified personnel only. The lightning flash with an arrowhead symbol, is intended to alert the user to the presence of un-insulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.

I M PO RTANT SAF ETY I N STR U CTI O N S

(Please read prior to installation)

1.Please read and observe all safety and operating instructions before installing your Series II unit. Retain these instructions for future reference.

2.The unit should not be used near water – for example, near a bathtub, washbowl,

kitchen sink, laundry tub, in a wet basement, near a swimming pool, etc.

3.Do not place your unit near heat sources such as radiators, heat registers, stoves, or other appliances that produce heat.

4.The units should only be connected to a

120VAC, 60Hz, 20 amp grounded electrical outlet. Do not defeat the ground or change polarization of the power plug.

5.Route the power cord and other cables so that they are not likely to be walked on, tripped over, or stressed. Pay particular attention to the condition of the cords and cables at the plugs, and the point where they exit your Pro

Series II unit. To prevent risk of fire or injury, damaged cords and cables should be replaced immediately.

6.Clean your Series II unit with a damp cloth

only. Do not use solvents or abrasive cleaners. Never pour liquid on or into the unit.

7.Your Pro Series II unit should be serviced by qualified service personnel when:

•The power supply cord or the plug has been frayed, kinked, or cut.

•Objects have fallen or liquid has spilled into the unit.

•The unit has been exposed to rain or other moisture.

•The unit does not appear to operate normally.

•The “Protection OK” indicator is not lit.

•The unit has been dropped, or the enclosure has been damaged.

•The retractable LED lights have failed. (not

applicable to the P8-PRO II)

8.Your Pro Series II unit requires that a safety ground be present for proper operation. Any attempt to operate the unit without a safety ground is considered improper operation and could invalidate the warranty.

9.Do not attempt to service your Pro Series II unit beyond what is described in this manual. All other servicing should be referred to qualified service personnel.

ADDITIONAL F E AT U R E S

PL-8 Pro Series II

The PL-8 PRO II features LED rack lights which produce virtually no heat and provide an extremely long life span. A dimmer control for the rack lights allows the user to adjust the level of illumination or simply switch the lights off. A rear mounted BNC jack accepts any standard (12VAC 0.5 amp) gooseneck lamp for rear rack illumination.