Farenheit Technologies T-910CM Name and Function of Each Part, Interface Switch Function

Page 5

NAME AND FUNCTION OF EACH PART

MENU Button

POWER Button

OSD MENU EXIT Button

Dome Light Button

 

 

 

CAUTION

CAUTION

Quality installations are best

Watching the monitor for an extended period of time

E

M

AVMENU

performed by qualified and

with the engine turned off

EXIT

ONOFF

AV Select Button

+/- Buttons

Interface Switch Function

Power Power ON/OFF

AV Signal Select

Menu Press this button for OSD menu.

And select menu option

certifled installers.

Dont touch the unit if there is a flash of lightning. It may receive an electric shock.

Do not cover heater ducts or vents. This may cause a fire or an electric shock.

may deplete the vehicle s battery.

This product is designed for operation with a 12 Volt DC, negative ground vehicle. It is not suitable for operation under other conditions or voltages.

+ Increase current option value. - Decrease current option value.

POWER KEY

AV1/AV2 KEY

 

MENU KEY

- KEY

+ KEY

LCD MONITOR

REMOTE CONTROL UNIT

7

Check Point

1.The operating temperature of this product is limited to 14 F~140 F (-10 C~60 C).

Your vehicle can reach temperatures up to 100 C in the summertime.

2.When your vehicle is extremely hot or cold you must allow time for your air conditioner or heater to cool or heat the vehicle and for operating temperatures to return to normal operating ranges. Your monitor will return to its normal functions when these operating ranges are achieved.

3.Optimum picture quality is achieved when you are directly in front of the monitor (+/-45 degrees).

4.If the buttons get stuck, please try to press the up of buttons, it will get back. It won't impact using normal.

5.If you cann't find the files name in list when playing, please reset units or turn off/on over again.

6.If the unit cann't be change mode when playing some special files which the unit didn't support, please reset units or turn off/on over again.

4

Image 5
Contents 910CM Specifications HOW to Operate the Monitor Connections There are two kinds of alarm symbols as followsName and Function of Each Part Interface Switch FunctionInstallation Plate Unit Screw a Screw B Installation Name and Function of Each Part