EVGA X58 3X SLI manual Installing System Memory DIMMs

EVGA X58 SLI Motherboard

Installing System Memory (DIMMs)

Your new motherboard has six 240-pin slots for DDR3 memory. These slots support 256 MB, 512 MB, 1GB, 2GB, 4GB DDR3 technologies. There must be at least one memory bank populated to ensure normal operation. Use the following the recommendations for installing memory. (See Figure 1 on page 14 for the location of the memory slots.)

One DIMM: If using 1 DIMM (Single Channel), install into: DIMM slot 1.

Two or Four DIMMs: If using 2 DIMMs (Dual Channel), install into: DIMM slots 1 and 3. If using 4 DIMMs (Dual Channel), install into: DIMM slots 2, 1, 4, and 3.

Three DIMMs: If using 3 DIMMs (Triple Channel), install into: DIMM slots 1, 3 and 5.

Six DIMMs: If using more than 4 DIMMs, use: DIMM slots 2, 1, 4, and 3

then proceed to occupy the following DIMM slots in this order: 5 and 6.

DIMM Slot 2

DIMM Slot 1

DIMM Slot 4

DIMM Slot 3

DIMM Slot 6

DIMM Slot 5

Use the following procedure to install memory DIMMs. Note that there is only one gap near the center of the DIMM slot. This slot matches the slot on the memory DIMM to ensure the component is installed properly.

1.Unlock a DIMM slot by pressing the module clips outward.

2.Align the memory module to the DIMM slot, and insert the module vertically into the DIMM slot. The plastic clips at both sides of the DIMM slot automatically lock the DIMM into the connector.

EVGA 19