Front Panel Features, Rear Panel Features

ETA-S15

Power Conditioner & Distribution Unit

FRONT PANEL FEATURES

1.Un-switched AC Outlet – The 120VAC outlet is always live when the ETA-S15 power cord is plugged into an AC mains power source and voltage is present. Note: The AC mains power switch does not affect the Unswitched AC Outlet. The Unswitched

Outlet is protected by the surge protection circuitry.

2.AC Mains Breaker – The 15A rated breaker will open if the combined draw of all AC outlets exceeds 15A. Note: The breaker is designed to exceed its rating for a short period of time. If the breaker is tripped, you must first remove the load from the ETA-S15 and then push to reset.

3.Power Switch – To turn the ETA-S15 on or off, press the switch to the ON or OFF position. The power switch will illuminate when in the “On” position.

REAR PANEL FEATURES

2	3	1

1.AC Mains Input – Connect the 9' (3m) power cord to a 15A 120VAC outlet to provide power to the ETA-S15.

2.AC Switched Power Outlets – These six outlets are “Live” when the front panel power switch is activated.

3.AC Unswitched Power Outlets – These two outlets are always “Live” when the ETA-S15 is plugged into a 120VAC source.

INSTALLATION

Before installing, we strongly suggest you read the entire manual to ensure you benefit from all the features of the ETA-S15. The ETA-S15 can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounted, placement within the rack is flex- ible however the ETA-S15 should be within 6' of a dedicated 15A AC outlet. When rack mounting, use Rack Rail screw type 10⁄32" x 1". Always make sure the 15A outlet is properly inspected by a certified electrician prior to connecting the ETA-S15. Make sure to inspect the equipment that is to be plugged into the ETA-S15 to ensure it does not exceed 15A total amperage draw.

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800-321-6699 • Fax: 800-996-3821

– 6 –

ETAsys.com

Specifications are subject to change without notice.