Envision Peripherals EN-980E user manual For Your Safety, FCC Statement

Page 2

For Your Safety

EN-980e

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4.Consult the dealer or an experienced radio/TV technician for help.

Notice

1.The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

2.Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits.

3.The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. It is the responsibility of the user to correct such interference.

As an ENERGY STAR® Partner, Envision Peripherals, Inc. has determined that this product

meets the ENERGY STAR® guidelines for energy efficiency.

Warning

To prevent fire or shock hazard, do not expose the monitor to rain or moisture. Dangerously high voltage is present inside the monitor. Do not open the cabinet. Refer servicing to qualified personnel only.

EN-980e

2

31MY02

 

Image 2
Contents User’s Manual Inch Flat CRT Color MonitorFor Your Safety FCC StatementPrecautions Package Contents Using the Right Power CordGeneral Features General NotesInstalling & Removing the Base Before You Operate the MonitorConnecting the Wires Using the Power Cord Supplied Before You Operate the Monitor Operating Instructions Front Panel ButtonsAdjusting the OSD Settings Plug & Play DDC1/2B Feature Windows INF Driver FileTechnical Support FAQ Problem Possible SolutionSpecifications AppendixEN-980eOptimal Viewing Mode 1280 x 1024 @ 85 Hz Factory Preset Timing Table Standard Resolution Horizontal VerticalConnector Pin Assignment