Envision Peripherals EN-7100e user manual Adjusting the OSD Settings

Page 12

Operating Instructions

EN-7100e

Adjusting the OSD Settings

1.Press the MENU button to open the OSD window.

2.Press the < or > buttons until the desired function is highlighted.

3.Press MENU to open the function’s window.

4.Press the < or > buttons to change the settings of the function.

5.To save and exit, highlight the EXIT icon and press MENU or leave the monitor alone for 10 seconds. If you want to adjust any other function, repeat steps 2-4.

Note: When the OSD window is open, the input signal timing settings appear at the top.

H:stands for horizontal frequency and

V:stands for vertical frequency.

EN-7100e

12

31MY02

Image 12

Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautionsEN-7100e Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor EN-7100e Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor EN-7100e Before You Operate the Monitor EN-7100e Install An Optional Wall Mounting Arm Not supplied Adjusting the Viewing Angle How to Install INF & ICM FileOperating Instructions Front Panel ButtonsAdjusting the OSD Settings How to Optimize the DOS-mode Plug & Play DDC1/2B FeatureDOS-mode Technical Support FAQ Problem Possible SolutionError Message Possible Solution Technical Support FAQ Resolution Vertical Pixels FrequencySpecifications AppendixEN-7100eOptimal Viewing Mode 1280 x 1024 @ 75 Hz AppendixFactory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number DescriptionLimited 3-Year Warranty Warranty