DTS DTS Pro Series manual Duration of all input audio files must be the same

DTS Pro Series Network Encoder for MAC OSX – Manager and User Guide

To select, double-click on the file in the list or highlight the file and click Open.

12.Repeat step 11 for the other channels.

Input files have been selected for all channels. For each input file, the sample rate, bit depth, and duration is identified. See note 1, below.

Use the duration information to check that the input files are identical in length. See note 2, below.

At bottom left, the estimated file size is displayed.

Make sure there is enough space in your output directory to store a file of this size.

αχ Special Case: This packer will accept a stereo source file to assign to a single channel.

The pulldown on the right is to select channel 1 or channel 2 from a stereo source file.

16

Manager and User Guide – DTS Pro Series Network Encoder for MAC OSX

αχ Note 1: If the sample rate of the input file does not match the sample rate you have chosen for the output file, a red outline will appear around the input file’s sample rate, as shown in this example.

Input file sample rate does not match the selected output sample rate. In this case, you must change the output sample rate to match (step 4) or provide inputs of the proper sample rate.

αχ Note 2: If the duration (length) of an input file does not match the duration of another input file, a red outline will appear around the input file’s duration, as shown in this example.

The duration of all input audio files must be the same.

13.Next, choose Pack remote file or choose Pack local file (if you are going to pack the file now but it will be encoded later – see page 20). Choose Close, if you do not want to continue. (Your selections so far will

be discarded.)

or

Click “Pack remote file” to generate the packed .agm file at the server. (If the output file already exists, packing will be aborted.)

You will be prompted to re-enter your password at this time.

This prompt will display when the packing is finished. (See Encoding Immediately after Packing, page 19).

If “Pack local file” is selected, this prompt will display when the packing is finished. (If the output file already exists, you will be prompted to overwrite it.)

17