Table | (continued) |
|
|
|
|
Setting | Options | Default |
|
|
|
Hard Loop ID |
| 125 |
|
|
|
•
•
•
•
•
Host Adapter BIOS. When this setting is disabled, the ROM BIOS on the QLA2xxx board is disabled, freeing space in upper memory. Do not disable this setting if you are booting from an FC disk drive attached to the QLA2xxx board. The default is Disabled.
Frame Size. This setting specifies the maximum frame length supported by the QLA2xxx board. The default size is 1024.
Loop Reset Delay. After resetting the loops, the firmware refrains from initiating any loop activity for the number of seconds specified in this setting. The default is 5 seconds.
Adapter Hard Loop ID. This setting forces the adapter to use the ID specified in the Hard Loop ID setting. The default is Disabled.
Hard Loop ID. If the Adapter Hard Loop ID setting is enabled, the adapter attempts to use the ID specified in this setting. The default ID is 0.
Advanced Adapter Settings
From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter Settings. The default setting for the QLA2xxx host adapter board is listed in table
Table A-2. Advanced Adapter Setting
Setting | Options | Default |
|
|
|
>4GByte Addressing | Enabled or Disabled | Disabled |
|
|
|
•>4GByte Addressing. This option should be enabled if the system has more than 4 gigabytes (GB) of memory available. The default is Disabled.
Scan Fibre Channel Devices
This option scans the FC loop and lists all the connected devices by loop ID. Information about each device is listed, for example, vendor name, product name, and revision. This information is useful when configuring your QLA2xxx board and attached devices.
Select Host Adapter
Use this setting to select a specific QLA2xxx board if you have multiple QLA2xxx boards in your system.