Dell C521 specifications Installing a Media Card Reader

Page 20

1

Media Card Reader

2

drive release latch

 

 

 

 

 

 

 

 

5. Replace the computer cover. See Replacing the Computer Cover.

NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the computer.

6. Connect your computer and devices to electrical outlets, and then turn them on.

Installing a Media Card Reader

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

1.Follow the procedures in Before You Begin.

2.Remove the Media Card Reader and bracket from its packaging.

3.If you are installing a new Media Card Reader:

a.Remove the drive-panel insert that blocks the FlexBay.

b.Remove the four shoulder screws from the drive-panel insert.

4.If you are replacing an existing Media Card Reader:

a.Remove the existing Media Card Reader.

b.Remove the four shoulder screws from the existing Media Card Reader.

5.Insert four shoulder screws into the sides of the Media Card Reader and tighten them.

6. Locate the correct guidance-slot for the Media Card Reader (slot 2) and align the shoulder screws with the screw guides.

Image 20
Contents September 2006 Rev. A00 About Your Computer Front ViewBack Panel I/O Connectors Back View of the ComputerBack to Contents Before You Begin Getting StartedRecommended Tools Turning Off Your ComputerPage Replacing the Computer Cover Removing the Computer Cover DDR2 Memory Overview Removing and Installing PartsMemory Installing Memory Cards Removing MemoryInstalling an Expansion Card Removing an Expansion Card Drives General Installation Guidelines Drive Interface ConnectorsPower Cable Connector Connecting and Disconnecting Drive CablesRemoving a CD/DVD Drive Installing a CD/DVD DriveCD/DVD Drive Floppy Drive Removing a Floppy DriveInstalling a Floppy Drive Media Card Reader Removing a Media Card ReaderInstalling a Media Card Reader Hard Drive Removing a Hard DriveInstalling a Hard Drive Battery Replacing the BatteryProcessor Removing the ProcessorInstalling the Processor Page Power Supply Replacing the Power SupplyFront I/O Panel Removing the Front I/O PanelRemoving the Fan Assembly Fan AssemblyInstalling the Front I/O Panel Removing the System Board Installing the Fan AssemblySystem Board Replacing the System Board Page Specifications Controls and Lights ConnectorsDrives Environmental PowerPhysical System Setup Entering System SetupOverview OverviewSystem Setup Options System64MB Boot Menu Post BehaviorClearing Forgotten Passwords and Cmos Settings Jumper Locations Clearing Password SettingsFlashing the Bios Clearing Cmos SettingsSystem Board Components Technical OverviewInside View of Your Computer Jumper Settings Jumper Setting DescriptionPin Number Signal name AWG Wire Power Supply DC Connector Pin AssignmentsDC Power Connector P1 DC Power Connector P2 DC Power Connector P3DC Power Connector P4 DC Power Connector P5 and P6Black +12 VDC Yellow September 2006 Rev. A00 Troubleshooting Dell DiagnosticsWhen to Use the Dell Diagnostics Dell Diagnostics Main MenuDiagnostic Lights Power Light Problem Description Suggested ResolutionProblem Description Suggested Resolution System LightsBeep Codes Code Cause