securing clips.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
3.Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
4.Remove the module from the connector.
1 | securing clips (2) | 2 | memory module |
Replacing Memory Module(s)
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
1.Align the notch in the module edge connector with the tab in the connector slot.
2.Slide the module firmly into the slot at a
NOTE: If the memory module is not installed properly, the computer may not boot. No error message indicates this failure.
1 | tab | 2 | notch |