Back to Contents Page
Power Button Module
Dell™ Inspiron™ 620s Service Manual
Removing the Power Button Module
Replacing the Power Button Module
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets,
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty.
Removing the Power Button Module
1.Follow the instructions in Before You Begin.
2.Remove the computer cover (see Removing the Computer Cover).
3.Remove the front bezel (see Removing the Front Bezel).
4.Disconnect the power button module cable from the system board connector, LEDH1 (see System Board Components).
5.Press the power button module tabs and pull the power button module to release it from the front panel.
1 
power button module 
2 
power button module tabs (4) 
6. Set aside the power button module in a secure location.
Replacing the Power Button Module
1.Follow the instructions in Before You Begin.
2.Align and push the power button module tabs into the slots on the front panel.