Back to Removing and Replacing Parts
Display Assembly
Dell™ Latitude™ E6410/E6410 ATG Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Display Assembly
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove the ATG port cover (applicable on E6410 ATG computer only).
3.Remove the battery.
4.Remove the hinge covers.
5.Remove the access panel.
6.Disconnect and unthread the antennae cable from the WLAN and/or WWAN card.
7.Disconnect and unthread the touch screen cable from the system board. (Only applies to E6410 ATG computer).
8.Loosen the captive screws that secure the display cable to the system board.
9.Disconnect and unthread the display data cable from the system board.
10.Remove the screws that secure the display assembly to the computer.
11.Lift and remove the display assembly from the computer.
Replacing the Display Assembly
To replace the display assembly, perform the above steps in reverse order.
Back to Removing and Replacing Parts