Dell P18S owner manual Working on Your Computer, Before Working Inside Your Computer

Page 7

Working on Your Computer

1

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your personal safety. Unless otherwise noted, each procedure included in this document assumes that the following conditions exist:

You have performed the steps in Working on Your Computer.

You have read the safety information that shipped with your computer.

A component can be replaced or--if purchased separately--installed by performing the removal procedure in reverse order.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as a connector on the back of the computer.

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.

CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.

7

Image 7
Contents Regulatory Model P18S Regulatory Type P18S001 Page Contents Removing The Wireless Local Area Network Wlan Card Removing The Hdmi Board Page Before Working Inside Your Computer Working on Your ComputerRecommended Tools After Working Inside Your Computer Turning Off Your ComputerPage Card Installing The Secure Digital SD CardPage Removing The Battery Installing The Battery Module SIM Card Installing The Subscriber Identity Module SIM Card Removing The Keyboard Installing The Keyboard Removing The Base Cover Installing The Base Cover Removing The Memory Installing The Memory Removing The Hard Drive Installing The Hard Drive Removing The Palm Rest Installing The Palm Rest Follow the procedures in After Working Inside Your Computer Page Network Wlan Card Installing The Wireless Local Area Network Wlan Card Network Wwan Card Removing The Wireless Wide AreaInstalling The Wireless Wide Area Network Wwan Removing The Display Assembly Page Installing The Display Assembly Page Removing The Display Bezel Installing Display Bezel Removing The Display Panel Page Installing the Display Panel Page Removing The Camera Installing The Camera Removing The Display Hinges Page Install the display assembly Installing The Display HingesPage Removing The Thermal Fan Installing The Thermal Fan Removing The System Board Lift up and remove the system board from the chassis Installing The System Board Page Removing The Coin-Cell Battery Installing The Coin-Cell Battery Removing The Heat Sink Lift up and remove the heat sink from the system board Installing The Heat Sink Page Removing The Hdmi Board Follow the procedures in After Working Inside Your Computer Removing The Speakers Installing The Speakers Board Installing The Input/Output I/O Board Removing the DC-In Port Lift up and remove the DC-in port from the bottom base Installing The DC-In Port Page Removing The Lvds Cable Install the display assembly System Setup Screens System SetupSystem Setup Overview Entering System SetupAction Main System Setup Menu OptionsAdvanced Security Exit Device Status Lights Diagnostics27LED Status Diagnostic Beep Codes Troubleshooting Steps Lights located above the keyboard indicate the following Keyboard Status LightsVideo Technical SpecificationsDisplay Keyboard AC Adapter Physical Storage 160 G Airborne contaminant level Contacting Dell Contacting Dell