Dell P52G owner manual Installing the System Board

Page 23

5.Lift and remove the system board from the chassis.

Installing the System Board

1.Insert the system board into the chassis.

2.Connect the I/O board connector to the system board.

3.Connect the eDP cable to the system board.

4.Connect the speakers to the system board.

5.Connect the power connector to the system board.

6.Tighten the screws to secure the system board to the computer.

7.Install:

a. palmrest assembly

23

Image 23

Contents Dell Vostro 14 Page Contents Diagnostics Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer Recommended ToolsAfter Working Inside Your Computer System Overview Removing and Installing ComponentsBattery Access panel Optical-disk drive System Board View Removing the BatteryRemoving the Optical-Disk Drive Installing the BatteryInstalling the Optical Drive Removing the Access PanelRemoving the Hard Drive Installing the Access PanelRemoving the Memory Module Installing the Hard DriveRemoving the Wlan Card Installing the Memory ModuleInstalling the Wlan Card Removing the Keyboard Removing the Palmrest Assembly Installing the KeyboardPage Removing the Coin-Cell Battery Installing the Palmrest AssemblyRemoving the Input/Output I/0 Board Installing the Coin-cell batteryRemoving the Speakers Installing the Input/Output I/O BoardInstalling the Speakers Removing the System Board Installing the System Board Removing the Display Assembly Page Installing the Display Assembly Removing the Camera Removing the Heatsink Installing the CameraRemoving the Power Connector Installing the Heatsink AssemblyInstalling the Power Connector Navigation Keys System SetupBoot Sequence System Setup Options CPU ID Wlan Computer or not Default Not Set System and Setup Password Updating the BiosAssigning a System Password and Setup Password Page Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsSpecifications SpecificationsUMA Display Battery Environmental Contacting Dell Contacting Dell