Dell 4690054, G615T appendix Organizing Your Cables, Attaching the Soundbar Optional

Page 38

If your monitor displays an image, installation is complete. If it does not display an image, see Solving Problems.

NOTE: If you are using DisplayPort cable as the input, change the input source through the OSD menu's Input source select option to DisplayPort.

•Use the cable management slot on the monitor stand to organize the cables.

Organizing Your Cables

After attaching all necessary cables to your monitor and computer, (See Connecting Your Monitor for cable attachment,) use the cable management slot to neatly organize all cables as shown above.

Attaching the Soundbar (Optional)

1.Working from the rear of the monitor, attach Soundbar by aligning the two slots with the two tabs along the bottom rear of the monitor.

2.Slide the Soundbar to the left until it snaps into place.

3.Connect the Soundbar with the DC power connector.

4.Insert the mini stereo plug from the rear of the Soundbar into the computer's audio output jack.

NOTICE: Do not use with any device other than Dell Soundbar

NOTE: Soundbar Power Connector +12V DC output is for optional Soundbar only.

Back to Contents Page

Page 37 Page 39
Image 38
Page 37 Page 39
Contents
Dell U2711 Flat Panel Monitor Users Guide Package Contents About Your MonitorProduct Features Identifying Parts and Features Front ViewBack View Front View Front panel controls Label DescriptionRight side Left side Label Description Side ViewBottom View Bottom view Label DescriptionPin Number Pin Side of the Connected Signal Cable Monitor SpecificationsPower Management Modes Pin AssignmentsComposite Video Connector DisplayPort Connector Video Supported Modes Flat Panel SpecificationsResolution Electrical Preset Display ModesPhysical Characteristics Universal Serial Bus USB Interface EnvironmentalPin Number Pin Side of the Signal Cable Card Reader SpecificationsPin Number Pin Side of the connector Transfer speedCaring for Your Monitor Maintenance GuidelinesPlug and Play Capability Slot Number Flash memory cards typeBack to Contents Appendix Visit support.dell.comSetting Up Your Monitor Click Change Display Settings Click Advanced Settings Using the Front Panel Operating the MonitorOSD Menu Exit Power button with power light indicator Using the OSD Menu Page Brightness Contrast Back Auto Adjust Input SourceScan Sources Component Composite Back Color SettingsImage mode submenu for VGA/DVI-D input DVI-D 1 DisplayPortPage Page Page PBP submenu when PBP OFF PBP Source PBP submenu when PBP onWhen PBP activated DDC/CI LCD Conditioning Factory Reset Back Personalize OSD Warning Messages VGA/DVI-D/HDMI/DisplayPort input Video Input Using the Tilt, Swivel and Vertical Extension Setting the Maximum ResolutionUsing the Dell Soundbar Optional Tilt/Swivel Vertical ExtensionClick Change Display Settings Dell U2711 Flat Panel Monitor Setting Up the Monitor Connecting Your MonitorOrganizing Your Cables Attaching the Soundbar OptionalSelf-Test Solving ProblemsBuilt-in Diagnostics Possible Solutions Common ProblemsCommon Symptoms What You ExperienceVideo Problems Product Specific ProblemsTroubleshooting the Card Reader Universal Serial Bus USB Specific ProblemsTroubleshooting the Dell Soundbar Cause ProblemSolution Drive Letter and Paths