Dell 2707WFP specifications Video Problems, Product Specific Problems, Common Symptoms

Wrong Color	Picture color not
	good
Image retention from	Faint shadow from
a static image left on	the static image
the monitor for a long	displayed appears
period of time	on the screen

•Change the color to "PC Custom Color" or "MAC Custom Color"

•Adjust R/G/B value of "PC Custom Color" or "MAC Custom Color"

•Change the Color Format to "PC RGB" or "YPbPr" (for Video/DVI-HD inputs)

•Use the Power Management feature to turn off the monitor at all times when not in use

•Alternatively, use a dynamically changing screen saver

Video Problems

COMMON

SYMPTOMS

No Video

Low Quality DVD playback

Blinking Video

WHAT YOU EXPERIENCE

No signal indicator is displayed

Picture not crisp and some color distortion

Video is blinking or discontinuous

POSSIBLE SOLUTIONS

•Check Video Input Selection

¡Composite: Yellow colored RCA jack

¡S-Video: Typically a round 4 pin jack

¡Component: Red, Blue, Green colored RCA jacks

•Check DVD connection

¡Composite gives good picture

¡S-Video gives better picture

¡Component: Red, Blue, Green colored RCA jacks

•Check DVD connection

¡Composite gives good picture

¡S-Video gives better picture

¡Component: Red, Blue, Green colored RCA jacks

•Check if DVD player is HDCP compliant.

¡Some non-compliant players may exhibit blinking video and others will display a raster scree

NOTE: When choosing S-Video, Composite or Component video, Auto Adjust function is not available.

Product Specific Problems

SPECIFIC SYMPTOMS WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS

Screen image is too small

Cannot adjust the monitor with the buttons on the front panel

The monitor will not go into power saving mode.

No Input Signal when user controls pressed

Image is centered on screen, but does not fill entire viewing area

OSD does not appear on the screen

No picture, the LED light is green. When press “+”, “-

”or “Menu” key, the message “ No S-Video input signal ”, “ No Composite input signal ” or “ No Component input signal ” will appear.

No picture, the LED light is green. When press “+”, “-

”or “Menu” key, the message “ No S-Video input signal ”, “ No Composite input signal ” or “ No Component input signal ” will appear.

•Perform monitor reset on "Factory Reset"

•Turn the monitor off and unplug the power cord and then plug back and power on

•Move mouse or hit any key on the keyboard on the computer or activate video player, then access the OSD to set Audio to “ off ” state.

•Check the signal source. Make sure the computer is not in power saving by moving mouse or pressing any key on the keyboard.

•Check to make sure Video Source to S- Video, Composite or Component is powered and playing video media.

•Check whether the signal cable is plugged in and seated properly. Re-plug the signal cable if necessary.

•Re-boot the computer or video player.