Dell U2212hm manual Removing the Stand, Wall Mounting Optional

NOTE: The Soundbar power connector (+12 V DC output) is for the optional Dell Soundbar only.

To attach the Soundbar:

1.At the back of the monitor, attach the Soundbar by aligning the two slots with the two tabs along the bottom of the monitor.

2.Slide the Soundbar to the left until it snaps into place.

3.Connect the Soundbar with the DC power connector.

4.Insert the mini stereo plug from the back of the Soundbar into the computer's audio output jack.

Removing the Stand

NOTE: To prevent scratches on the LCD screen while removing the stand, ensure that the monitor is placed on a soft, clean surface.

NOTE: This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for the set up instructions.

To remove the stand:

1.Place the monitor on a flat surface.

2.Press and hold the stand release button.

3.Lift the stand up and away from the monitor.

Wall Mounting (Optional)

(Screw dimension: M4 x 10 mm).

Refer to the instructions that come with the VESA-compatible base mounting kit.

1.Place the monitor panel on a soft cloth or cushion on a stable flat table.

2.Remove the stand.

3.Use a screwdriver to remove the four screws securing the plastic cover.

4.Attach the mounting bracket from the wall mounting kit to the LCD.

5.Mount the LCD on the wall by following the instructions that came with the base mounting kit.

NOTE: For use only with UL-listed wall mount bracket with minimum weight/load bearing capacity of 4.52 kg.

Back to Contents Page