Dell SE178WFP Setting Up Your Monitor, Connecting Your Monitor, Using the Front Panel Buttons

Page 10

Back to Contents Page

Setting Up Your Monitor

Dell SE178WFP Flat Panel Monitor User's Guide

Connecting Your Monitor

Using the Front Panel Buttons

Using the OSD

Using the Dell Soundbar (Optional)

Connecting Your Monitor

CAUTION: Before you begin any of the procedures in this section, see the Safety Instructions.

1.Turn off your computer and unplug its power cable.

2.Connect the blue (analog D-sub) display connector cable to the corresponding video port on the back of your computer. (The graphic is for illustration only. System appearance may vary).

3.Connect the power cable for your display to the power port on the back of the display.

4.Plug the power cables of your computer and your display into a nearby outlet. Your monitor is equipped with an automatic power supply for a voltage range from 100 to 240 Volt at a frequency of 50/60 Hz. Be sure that your local power is within the supported range. If you are unsure, ask your electricity supplier.

5.Turn on your display and computer.

If your monitor displays an image, installation is complete. If it does not display an image, see Troubleshooting.

Using the Front Panel Buttons

Use the control buttons on the front of the monitor to adjust the characteristics of the image being displayed. As you use these buttons to adjust the controls, an OSD shows their numeric values as they change.

The following table describes the front panel buttons:

Page 9 Page 11
Image 10
Page 9 Page 11
Contents About Your Monitor Product Specific Problems Dell SE178WFP Flat Panel Monitor Users GuideFront View About Your MonitorBack View Side View General Monitor SpecificationsBottom View Right side Left sideFlat Panel ResolutionPreset Display Modes ElectricalPower Management Modes Physical CharacteristicsEnvironmental Pin Number Pin Side of the Connected Signal Cable Power Management DefinitionPin Assignments Caring for your Monitor LCD Monitor Quality & Pixel PolicyPlug and Play Capability FCC Notice U.S. Only and Other Regulatory Information AppendixContacting Dell Connecting Your Monitor Setting Up Your MonitorUsing the Front Panel Buttons On Screen Menu/Display OSD Using the OSDMenu Exit Image settingsIcon Menu Name and Sub- menus Description This is used to exit out of the Main MenuSettings OSD Settings PositionLanguage Factory Reset Automatic Save Using the Dell Soundbar OptionalOSD Warning Messages Soundbar Attachment to the Monitor Monitor Specific Troubleshooting Product Specific ProblemsCommon Problems Product Specific Problems Specific Symptoms What YOU Experience Possible SolutionsBack to Contents Attaching the Stand Using Your Monitor StandOrganizing Your Cables Using the Tilt Removing the Stand
Related manuals
Manual 2 pages 15.47 Kb
Top Page Image Contents