Dell S2309W appendix Operating the Monitor, Using the Front Panel, Input Source Select/Select

Back to Contents Page

Operating the Monitor

Dell™ S2309W Flat Panel Monitor User's Guide

Using the Front Panel Controls

Using the On-Screen Display (OSD) Menu

Setting the Optimal Resolution

Using the Dell Soundbar (Optional)

Using the Tilt

Using the Front Panel

Use the control buttons on the side of the monitor to adjust the characteristics of the image being displayed. As you use these buttons to adjust the controls, an OSD shows the numeric values of the characteristics as they change.

Front panel Button

1
	OSD Menu/Exit
2
	Brightness /Contrast Hot
	Key
2 and 3	/
	Down and Up
3
	Auto Adjust

Description

The Menu button is used to open and exit the on-screen display (OSD), and exit from menus and sub-menus. See OSD Menu.

Use this button for direct access to the "Brightness" and "Contrast" control menu.

Use these buttons to navigate and adjust the slider bar (decrease/increase ranges) controls in the OSD menu.

Use this button to activate automatic setup and adjustment. The following dialog appears on a black screen as the self-adjusts to the current input:

Auto Adjustment button allows the monitor to self-adjust to the incoming video signal. After using Auto Adjus can further tune your monitor by using the Pixel Clock (Coarse), Phase (Fine) controls in the OSD.

NOTE: Auto Adjust does not occur if you push the button while there are no active video input signals or attac cables.

4

/

Input Source Select/Select

Use the Input Source Select button to select between different video signals that may be connected to your monito

•VGA input

•DVI-D input

As you cycle through the inputs you will see the following messages to indicate the currently selected input source. take a few seconds for the image to appear.