AUX Video Input D-Sub 9-Pin | Datavideo TLM-70D specification

(See Note 1 below)

9. AUX Video Input (D-Sub 9-Pin):

An additional video input terminal with RGB and Sync input interface. Connect the Pin 7 to Ground (Short the Pin 7 & 8) to activate this interface and turn on the 12VDC power output on Pin 1 & 6.

PIN 1: 12VDC 300mA output

PIN 2: Video “R”Input

PIN 3: Video “G”Input

PIN 4: Video “CV_Sync”Input

PIN 5: Video “B”Input

PIN 6: 12VDC 300mA output

PIN 7: SDI Switch (Connect to Ground to enable RGB Input of Pin 2-5)

PIN 8: Ground

PIN 9: Ground

10.DIP Switch setting for DV Input mode select

Please refer to the setting below for proper operation.

S1. PAL or NTSC (PAL-ON, NTSC-OFF)
S2. NTSC setup level 7.5 IRE / 0 IRE (ON: 0 IRE, OFF: 7.5 IRE). (See Note 2 below)
	S3. Locked Audio (OFF: Locked Audio, ON: Unlocked Audio, factory default)
	S4 & S5 setting for different PC Operation System

S5	ON	S4	ON	MAC OS (See Note 3 below)
			OFF	Windows 2000 and Windows 98

S5	OFF	S4	ON	Windows XP and Windows ME
			OFF	DV Camera mode

S6. Factory setting (OFF), please do not change.

*. Note 1: Reboot TLM-70D if you change a DIP Switch Turn-on TLM-70D before launching any NLE software

*. Note 2: NTSC 0 IRE is most often used in Japan NTSC 7.5 IRE is used elsewhere

*. PAL Video is always at 0 IRE mode

*. Note 3: To work with a DV source from MAC with Final Cut Pro: 1). Select "Preferences" from Final Cut Pro menu

2). Select "General" page

3). Uncheck "Abort capture on dropped frame"

4). Uncheck "Abort capture on time code break" for Final cut pro

5). Click OK button