Diamond Systems High INtegration PC/104 Celeron CPU with Ethernet, 1.01 Technical Support

Page 21

9.4Booting into Linux or Microsoft Windows

This section describes how to setup Morpheus in preparation for a Linux or Windows install from an installation CD-ROM onto a laptop IDE hard drive.

1)Connect the IDE extender board to IDE channel.

2)Connect a CD-ROM drive jumpered for the slave position to the IDE extender board through the 40-pin cable.

3)Connect power to the CD-ROM drive.

4)Connect a laptop hard drive jumpered for master position to the second slot of the 44-pin cable.

5)Power up and boot Morpheus.

6)Morpheus starts BIOS power-on self test (POST.) At this screen hit <DEL> to enter BIOS configuration.

7)Go into “Advanced BIOS Features” and ensure that the CD-ROM drive is first boot device.

8)Insert the boot CD for your operating system into the CD-ROM drive.

9)Save BIOS settings and reboot.

10)Morpheus should now boot off the CD and start the OS installation process.

10.TECHNICAL SUPPORT

For technical support, please email: support@diamondsystems.com or contact Diamond Systems technical support at 1-510-456-7800.

Morpheus CPU User Manual V1.01

Page 21

Page 20 Page 21
Image 21
Page 20 Page 21
Contents Morpheus Table of Contents Description FeaturesBoard Layout and Drawings Board Layout Top View Connectors and JumpersBoard Layout Bottom View Jumper and I/O Headers Jumper Settings Cmos Jumper Settings J1Serial Port Selection RS232C/422/485 J5 System I/O RS-485 RS-422CPU Fan Ethernet LEDLCD VGAIDE Floppy Disk Drive USBIrDA Infrared Power 10 PS/2 Keyboard and MouseParallel Port Ethernet 100 Base-Tx UtilitiesConnections Description Pin Direct Memory Access System ResourcesInterrupt Assignment IRQ Resource Description I/O Address Description EC00 Ecff Part Number Description AccessoriesMorpheus Cable Kit IDE Configuration General SetupBooting into MS-DOS, FreeDOS or ROM-DOS Quick Start GuideTechnical Support Booting into Linux or Microsoft Windows
Top Page Image Contents