Computer Tech Link CTL 5xn user manual Setup, Installing the TILT/SWIVEL Stand

Page 8

SETUP

INSTALLING THE TILT/SWIVEL STAND

1.Ensure that the power to the monitor is off.

2.Set the monitor face down with the underside facing you. Please be careful so as not to scratch the monitor screen.

3.Align the four hooks on the stand with the guide holes of bottom chassis of the monitor.

4.Insert the hooks into the guide holes.

5.Slide the tilt/swivel stand toward the front of the monitor until the latch locks in position.

6.Turn the monitor and the stand upright.

English

2

PUSH

1 PUSH

<Removing the tilt/swivel stand>

If you want to remove the tilt/swivel stand on the monitor, press the latch and pull the tilt/swivel stand toward the back of the monitor. Lift the stand to separate.

3

Image 8
Contents User Smanual Important Safeguards Canadian Department of Communications Compliance Statement Page Contents Introduction EnglishProduct Features Setup Installing the TILT/SWIVEL StandConnecting the Power Cord Connecting the D-SUB Signal CableConnecting to Your Macintosh Computer English Operation & Adjustment OSDOn-Screen Display Menu OSD On-Screen Display Menu Specifications Picture TubeFactory Preset Timings Mode Resolution Freq KHz Freq Hz RemarkTroubleshooting Symptom Check No pictureDescription for D-SUB Connector Appendix