Citizen Systems CBM-910 Type II user manual Self-Printing Function

Page 22

4.5 Self-Printing Function

When activating self-printing function, be sure to start with a paper loaded (or in the printable state).

(1)Test printing

Turn the printer power on while pressing and holding the LF switch, and the printer starts printing the status of current setting of DIP switch (including the content of setting in case of serial printer) and all characters available with the printer.

The SEL lamp is held off and BUSY signal is output during test printing.

On completion of test printing, the printer enters the standby state awaiting print data.

(2)Hexadecimal dump mode

Turn the printer power on with the LF switch and SEL switch pressed and held. The printer prints Hexadecimal Dump characters and then prints all data sent from the host in hexadecimal code.

When data for the last line is not sufficient for full one line, data of the last line is printed out with SEL switch pressed and deselected (OFF LINE).

This mode lasts till power is turned off.

Example of Printing in Dump Mode

31	32	33	34	35	36	37	38	12345678
39	3A	3B	3C	3D	3E	3F	40	9*+,-./@
41	42	43	44	45	46	47	48	ABCDEFGH
49	4A	4B	4C	4D	4E	4F	50	IJKLMNOP
51	52	53	54	55	56	57	58	QRSTUVWX

— 18 —

Image 22

Contents DOT Matrix Printer Weee Mark Page Declaration of Conformity General Precautions Safety Precautions -WHICH should be Strictly Observed Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Accessories FeaturesIntroduction Type AC AdapterSpecifications CBM-910II-24 CBM-910II-40External Appearance and Part Descriptions External AppearancePart Descriptions OFFOperations Connection of the AC AdapterSetting of the Printer Cover Setting Ribbon Cassettes Setting Paper Special Remarks Concerning Paper Self-Printing Function Memory Switch Setting Japan 910JPNUSA = U.S.A Paper-Near-End, Mechanical Alarm, Memory Error General Remarks Pin Signal Name Connector Pin AssignmentParallel Interface Description of Input/Output Signals Electrical Characteristics Serial Interface Pin Signal Name Signal Direction Function RS-232C Host-PrinterDescription of Input/Output Signal DTR Data Terminal ReadyTTL circuit Input Reset Error Detection Receiving Control and BufferingFactory Setting DIP Switch SettingSwitch No Function Switch No Parity Baud Rate Factory SettingParallel Interface Type Print Control Function Symbol Code Function CBM910 IDP3110 HexadecimalList of Control Codes Control Code Details Abcd Page Country Character Code TableESC Page FF FF FF FF FF FF For 40-column model 3110 emulation Page Model 123 CR Function Content of Setting Character Code Table Ascii + 910 Emulation International 910 Emulation JapanCodepage PC437 USA, Standard Europe Katakana Codepage PC858 Multilingual Codepage PC860 Portuguese Codepage PC863 Canadian-French Codepage PC865 Nordic Codepage PC852 Eastern Europe Codepage PC866 Russian Codepage PC857 Turkish Codepage WPC1252 Windows Latin1 Codepage PC864 Arabic Codepage PC869 Greek International Character Code Table External Dimensions Page

Related manuals

Manual 62 pages 22.59 Kb