Precautions in Handling the Printer

WARNING

Please observe the following precautions for power source and power cord:

●Do not plug or unplug the power cord with a wet hand.

●Use the printer only at the specified supply voltage and frequency.

●Use only the specified AC adapter with the printer.

●Check to make sure that the supply outlet from which the printer is powered has a sufficient capacity.

●Do not supply the printer from a power strip or current tap shared with other appliances.

●Do not plug the power cord into a supply outlet with dust or debris

left on its plug.

●Do not use a deformed or damaged power cord.

●Do not move the printer while the printer power is on.

• Neglecting to handle properly may result in printer failure, emission of smoke, fire, or electric shock.

• An overload may cause the power cord to overheat or fire or the circuit breaker to trip.

● Do not allow anything to rest on the power cord. Do not place the printer where the power cord will be trampled on.

● Do not use or carry the printer with its power cord bent, twisted, or pulled.

● Do not attempt to modify the power cord unnecessarily.

●Do not lay the power cord in the neighbor of a heating device.

•Neglecting these cautions may cause wires or insulation to break, which could result in leakage, electric shock, or printer failure. If a

power cord sustains damage contact your CITIZEN SYSTEMS dealer.

●Do not leave things around the supply outlet.

● Supply power to the printer form a convenient wall outlet, readily accessible in an emergency.

•The printer may not be immediately shut down in an emergency. ● Insert the power plug fully into the outlet.

● If the printer is not to be used for a long time, leave it disconnected from its supply outlet.

●Hold the plug and connector when plugging or unplugging the power cord or signal cable after turning off the printer and the appliance connected to it.

— 5 —