Citizen Systems iDP-3530 user manual Citizen

Page 11

iDP-3530 User’s Manual

4-3 Loading and Changing the Paper

Using Paper Roll

1)Cut the paper in right angle to its longitudinal center line as shown in Fig. 7.

2)Insert the paper into insertion inlet on the rear side of printer.

3)Turn on the power switch and feed the paper by pushing the LF switch.

4)When the printing paper comes out of the clearance (paper cutter part) on the printer cover, fix the paper by means of paper holder, then set in on the main unit.

Fig. 6

Using Fan-fold Paper

1)Remove the printer cover.

2)Set the imprint face of the paper down ward and put into the paper entrance.

3)If necessary to adjust the sprocket-wheel’s position, free the wheels using the lever on both side. Slide them to the appropriate position, and lock them back.

4)Hook some of the paper’s perforations on the sprockets and forward the paper into the printer mechanism by pulling and turning the paper-feed knob until the paper’s tip reaches the platen.

Fig. 8

CITIZEN

11

Image 11
Contents User’s Manual Citizen Contents Introduction Basic Specifications 7 dots Incl. Half dot Composition External Appearance and Parts Descriptions Lamp is on. This lamp may blink on the following occasions GND Preparation Citizen Citizen Citizen DTR FaultSerial Interface UPD4711 or equivalent Output DTR,FAULT Printer side Citizen STB ACK, BUSY, STB, FaultGND Fault Parallel InterfaceACK DataCitizen Citizen France Germany England OFF OFFSelect Deselect CR + LFCitizen BEL Print Control FunctionsCan Data IDP-3530 User’s Manual Form Feed Maintenance Initial SettingCharacter Code Tables IDP-3530 User’s Manual Individual Country Character Codes