ADJUSTMENTS
❒Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1 1/2 minute warm up periodbeforeitwilldetectmotion.When first turned on or when switching from Manual to Auto mode wait 1 1/2 minute.
Avoid aiming the control at:
•Objects that change temperature rapidly, such as heating vents and air condition- ers. These heat sources could cause false triggering.
•Areas where pets or traffic may trigger the control.
•Nearby large,
150° |
5 ft. |
(1.5 m) |
30 ft.
(9.1 m)
Maximum | Maximum |
Range | Coverage Angle |
The detector is less sensitive to motion directly towards it and more sensitive to across motion.
MotionMotion
Sensor
Least Sensitive | Most Sensitive |
❒Walk through the coverage area noting where you are when the lights turn on. Loosen the 3 clamp screws slightly and turn the sensor head left or right to change the coverage area.
❒When you have the desired coverage angle make a pencil mark on the sensor and post to mark the sensor position.
❒If you need to change the sensitivity, temporarily lift the fixture and sensor to make the adjustment. It may be neces- sary to have a friend hold the fixture while adjusting the sensitivity. Too much sensitivity may increase false triggering.
❒Set the amount of ON TIME you want the light to stay on after motion is detected. (1, 5, or 20 minutes).
TEST 1 5 20 MIN | OFF 3 6 | DUSK TO |
| HOUR | DAWN |
❒Set the Dual Light Level (ACCENT) switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs.,
❒Put the sensor and fixture back in place. Alignthepencilmarksmadeabove.Tighten the three screws to secure the sensor.
Securing Brass & Plastic Post Lamps
❒Turn power off at circuit breaker.
❒Turn the post lamp to the desired loca- tion. Using a #31 drill and the fixture as a template slightly mark the location of one of the fixture mounting holes. DO NOT drill through the sensor plastic.
❒Lift the fixture off the sensor and keep the wires away from where you need to drill. Now finish drilling the first hole.
❒Set the fixture in position and install a screw (provided) to hold the fixture.
❒Mark the remaining holes as above.
❒Remove the one screw and lift the fixture and drill the remaining holes as above.
❒Set the fixture in position and install all the screws (3 provided). Be careful to not over tighten the screws and strip out the plastic.
3 |