AOC CT500G user manual Power Cord, Video Cable

INSTALLATION INSTRUCTIONS

OPERATING INSTRUCTIONS

SWIVEL BASE

GENERAL INSTRUCTIONS

To attach

the

swivel

base to

the

monitor,

do

the

following:

The power switch is located at front panel of the monitor.

Press

the power switch to turn

the

monitor on

or off. The

∙ Carefully turn the monitor on its side or upside down. (see

are located at

the base of the monitor

figure 1)

other

control

knobs

(See Figure 3). By changing these settings, the

picture can

∙ Locate the cavities at the bottom front of the monitor.

∙ Insert

the pegs on the swivel

base

be adjusted to your personal preferences.

into these

cavities.

∙

The power cord should be connected.

Push the swivel base forward until the swivel base locks in

cable

from

the

monitor to

the

video

place.

∙

Connect the

video

card.

∙ To remove the

swivel base, hold the bottom of the swivel

monitor on,

press

the

POWER switch to

ON

base, then push it out.

∙

To turn the

position. The power indicator will light up.

POWER CORD

∙ Your monitor features a unique quick switch system which

Power Source:

provides a picture within seconds

after the

monitor is

1. Make sure the power cord is the correct type that

required in your area.

switched on.

2. This monitor has a universal

NOTES

allows

power supply that

∙

Do not install the monitor in a location near heat sources

operation in either 100/120V AC or 220/240V AC voltage

area

such as radiators or air ducts ,

or

in a place subject to

(No user adjustment is required).

direct sunlight , or excessive

dust or mechanical vibration

3. Connect the power cord into your monitor￿s shockpower.

input socket, and then plug the other end into∙ Save 3the-pinoriginalAC

shipping carton and packing materials,

power outlet. The power cord may be connected to either

come

in handy if

you ever have to ship your

as they will

a wall power outlet or the power outlet socket

your PC,

monitor.

depending

on

the type

of power

cord

supplied with your

monitor.

∙

For maximum protection, repackage your monitor as it was

∙

originally packed at the factory.

VIDEO CABLE

To keep the monitor looking new, periodically clean it with

Connecting

the

Video theCable:monitor

comes

with aa soft cloth. Stubborn stains may be removed with a cloth

built-in video cable. Plug ′sthe15-sigpinalconnectorcable

lightly dampened with a mild detergent solution. Never use

into the computer’s video port and tighten the two screws on

thinner,

benzene, or

abrasive

the cable connector. (see figure 2)

strong solvents such as

cleaners, since these will damage the cabinet. As a safety

Caution:Don￿t bend the

signal cable,

otherwise it will

break the inner wire.

precaution, always unplug the monitor before cleaning it.

Connecting the PowerPlugCord:the power cord into the

monitor’s AC power jack. Then plug the power cord into a

grounded

AC outlet, UL-approved power strip, or the power

output socket on your PC.

Caution: If the AC outlet is not grounded, install the proper grounding adapter (not supplied).

6