AOC 916VWA user manual

Page 6

1.Power

2.audio

3.DVI

4.Analog

Turn off your computer before performing the procedure below.

1.Connect the power cable to the AC port on the back of the monitor.

2.Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect the other end to the computer's D-Sub port.

3.Turn on your monitor and computer.

If your monitor displays an image, installation is complete. If it does not display an image, see Troubleshooting.

Image 6

Contents National Conventions PrefaceAbout This Guide Product RegistrationSafety Introduction HG Declaration Setup PrecautionsAdjusting Viewing Angle Attaching the Cables Page Attaching Wall Mounting Arm Click Settings Click Control Panel Using the MonitorSetting the Optimal Resolution Click SettingsOSD Settings DCB Adjustment What is DCB?How to use Color Boost? Page Page Page How to use Picture Boost? DCR Adjustment What is DCR?How to Use DCR? DCR Demos Function Control IllustrationDCR Windows LED IndicatorsDrivers Windows MEWindows XP Frequently Asked QuestionsTechnical Support Windows VistaSpecifications Product InformationPreset Display Modes EPA Energy StarFREQUENCYkHZ FREQUENCYHz Pin Number Pin Side of the Signal Cable Pin AssignmentsStack